GDS-4005 is
an electronic circuit designed for installation in automatic electric gun. It
removes loss of energy which occurs while mechanical trigger contacts touch each
other. It protects your AEG by eliminating trigger burn-out. Thanks to MOSFET
the battery energy is not lost while burning trigger contacts but is directed
straight to the motor. In this way we get bigger rate of fire which results in
faster trigger response.
The circuit is compatible with all the replicas, also the tuned
ones. It works with 7.2 V packets without any problems. It doesn't consume
energy while stand-by.
Specification:
The circuit was made in SMT technology. A special laminate was
used for production, assigned for high-current circuits. The thickness of the
copper track is 105um while 18um is standard. Mosfet itself is
one of the best in its category. Its resistance is only 0.003
ohm, thanks to that the circuit doesn't heat up. Another advantage is
the fact that it was produced in Logic Level Technology - it
has excellent parameters while the voltage is only 4.5V. Additionally it is
protected with two transils, with the power of 600W each -
without any problems it co-operates with the most powerful motors (e.g. Magnum).
The circuit has a built-in radiator which ensures additional thermal capacity as
well as enables to give off heat. Thanks to that it will handle even the longest
series at a very high load.
HEXFET:
Maximum voltage:30 volt
Minimum voltage:
3.3 volt'a
Internal resistance: 0.003
ohm
Maximum continuous current: 260 A
Maximum
instant current: 1040 A
Maximum continuous power:
330 W
Reaction time: 40
ns
GDS-4005:
Dimensions: 3cm x 1.3cm
x 1.0cm
Weight: 3.5g
|
|
Assembly is very simple, but one additional lead from the trigger
is required.
Warranty
12 months.
